3/21/2024 0 Comments Tapcon drill bit sizes chartTapcons can be used in a variety of applications, including attaching framing to a concrete wall, fastening. The recommended drill bit size for a 1/4 Tapcon screw is 3/16 inch. For example, a 3/16 Tapcon screw would require a 5/32 drill bit. Generally, the larger the screw, the larger the drill bit will be. Drive anchor using a hammer drill with nut driver or Phillips bit until fully seated.įor Classic Blue Hex Washer Head and Phillips flat, Refer to the chart below:įor classic Blue Tapcon Concrete Screw you can either use a classic drill bit, SDS-Plus (Fits SDS PLUS style Hammer Drills) or we have a section of dedicated tapcon drill bits. The size of drill bit you will need for a Tapcon screw depends on the size of the screw itself. Using a blow out bulb or compressed air, remove dust from hole. A 5/32 inch bit is used for 3/16 inch Tapcons, and a 3/16. The large diameter Tapcons use regular ANSI standard bits. drill the holes, going through the plate and into the floor with the correct size masonry drill bit. ![]() These bits can be used for either the standard blue Tapcon or the stainless steel Tapcons. Nail-Type Point guides the anchor into the pre-drilled hole. The 5/32' bit is used for the 3/16' Tapcon® concrete screw and the 3/16' bit is used for the 1/4' Tapcon. Lengths of Tapcon Anchors range from 1-1/4 to 4 in 3/16 and up to 6 in 1/4 diameters. Use the charts below to select the correct drill bit. Tapcon® concrete screws tap threads into a predrilled hole in concrete, brick or block. For your convenience, we’ve compiled a simplified chart of drill bit sizes. Some values are rounded to their nearest thousandth millimeters and ten-thousandth decimal inches. ![]() Some metric values are close enough to essentially have the same imperial counterpart. When it comes to understanding what type, size and length Bright Fasteners has got you covered.įirst you must understand the installation process of Tapcon Screws:ĭrill using a hammer drill, drill hole 1/4" deeper than anchor embedment. Not all metric drill bits have imperial equivalents, and vice versa. It's import to use the correct drill bit for the installation of a Tapcon Concrete Screw. Safe working loads for single installation under static loading should not exceed 25 of the ultimate load capacity.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |